BritishV8 Forum

FOR SALE: Set of used SBF headers, purchased from Coyote Engineering, made specifically for a Ford small block conversion in a MGB . They have been ceramic coated and show normal wear and tear after 4 seasons of use..


      Asking $350usd + actual shipping costs.

Are through the wheel well or huggers?

These are through the wheel well - a couple of photos in the photo gallery......
http://www.britishv8.org/MG/GrahamCreswick.htm

Thanks for the reply. Looking for set of block huggers before I bite the bullet and put in call to Fast Cars.

Nobody makes 302 block huggers for an MGB besides Fast Cars. Even those will require some frame rail massaging.

How so on the frame rail massage? I'm running a SBF w/dry sump that lets the motor sit down a bit further in the bay. Looks like (fatal words) there should be a good bit of clearance but, this is my first rodeo on this type of conversion and I will defer to those who have already been there and done that. Nice looking headers BTW. Just not into cutting out the wheel wells (yet).

Dan Master's GT has the Fast Cars blockhuggers. You might PM him to find out what is involved with the installation.

You can see more of Dan's photos in the Photo Gallery.

FYI - Ted now builds mild steel block huggers. $800 for the pair.

Cheers

Pete

I might bite on these as I'm getting ready to start my conversion. I just have to ask. Why are you getting rid of them? Putting a turbo in or something?

By the way, the only time was around any was at Townsend a few years back. I roamed the parking lot at the motel one evening asking a lot of questions.

Steve

Still got these headers?? I'll take em off your hands...

I will take these if they are still available chadnhr@yahoo.com

Sorry gents - they were sold some time ago...I should have updated the post accordingly!