1966 Apline saw on YouTube a mopar v8

[mylocker]

I would like to figure out how to squeeze in a mopar 273 I was surfing YouTube and came across a V series with a Mopar V8 I have a 273 commando that I would like to fit in any thougts

[mgb260]

Chrysler looked at it and gave up. They were hoping to replace the SBF in the Tiger. I have seen some SBC swaps where the cut out the hood latch area for a rear distributor fit. There are a few LS installs also but the entire front end is stubbed out and with aluminum  inner fenders. Kind of Pro Street, like this BBF in a early Alpine on this site. You will need rack and pinion steering. That said, the 360 is the same externally as the 273.

http://www.britishv8.org/Other/DavidPark.htm

[mylocker]

https://youtu.be/QD0h8Ncv0Zg

That's the YouTube video showing the mopar engine installed and which rack and pinion setup is needed
Thanks

[mgb260]

Here is a small block Chevy install:

http://alpinerestoration.blogspot.com/

[mylocker]

That was pretty cool a 327 ...

[mgb260]

Here is the LS motor in a Alpine:

https://www.youtube.com/watch?v=vJWl9UJfBgs