engine mounts for rover engine to Triumph TR4

pjetri6@aol.com · January 31, 2016, 02:34:13 PM

Hello, anyone out there know of someone who makes engine and trans mounts for a Rover 3.9 engine and a 5 speed trans from a Triumph TR7-8 into a Triumph TR4. I have seen several suppliers that make them for a MGB, but have not come across pre made mounts for the Triumph. I would be thankful for any help. Thanks again, Paul

tbo · January 31, 2016, 08:22:12 PM

You can check out the numerous builds here on the website . Lots of swaps Rover into TR4 and TR6 same frame basically . Lots of pictures too of custom mounts. You may find a supplier through checking out the installations. It will give you some good tips also.

pjetri6@aol.com · January 31, 2016, 08:32:59 PM

Thanks Tim, I have read quite a few messages on the website. Unless I missed something I have not seen the info I am looking for, that's why I posted this message.

BWA · January 31, 2016, 08:42:30 PM

Try sending a pm to this guy as he put a Rover engine in his TR6.

http://www.britishv8.org/Triumph/MarkBrown.htm

Cheers
Byron

Dan B · January 31, 2016, 10:37:09 PM

There is a little difference in the motor mounts between a 4A and a 6, and the front part of the frame on a 6 is a little different, so take that into account as you do your research.

Royal · August 31, 2019, 02:18:53 PM

Hi, I'm new here so I may not be searching right but, I could use some help with info on Motor Mounts for a Rover 3.9 going in a TR4A solid axle. I searched several ways but can't seem to find and usable info / photos.

Thanks,
Roy

MGBV8 · September 01, 2019, 12:17:47 PM

I've not seen any offered. Likely have to make your own.

Royal · September 01, 2019, 04:22:22 PM

Copy, just looking for a picture of the mounts others have used and for an idea for the best motor placement.

blue4 · February 19, 2020, 08:55:22 PM

Try D&D they advertise motor mounts for 215 that bolt to engine,they might have info about frame.