SOLD - Firebird rearend narrowed and mounts welded for MGB

[declan]

80's Firebird rear end, 5 lug(bolt pattern same as MGC 5 lug), disc brakes, limited slip, "3:3/1 I think", and mounts to fit rubber bumper MGB (this may be the same as the chrome bumper?). The brakes will need a proportioning valve in line when you set up the new lines. $1200

[maxwedge5281]

w2hat is the width from bolt on to bolt on surface? i am looking for a narrowed rear for an austin healey 3000. thanks

[declan]

53" wide, outermost brackets pictured are 38" apart, innermost are 25" apart.

[declan]

$900

[MGBV8]

Your ad on MGExp says 52" wide.  53" or 52"?

[declan]

52", but I will measure again to be sure.

[limey222]

Given the high cost of truck freight for this unit, I would offer $700 for it providing its length is 52" and it is around a 3.3 ratio.  My reasoning is that I have been strongly considering  a Quaife LSD installed in my MGC 3.07 axle which would cost me about the same once shipping is thrown in.

[declan]

Not sure how I miss measured, my flat edge may have been on a stud. Wheel mating surface to wheel mating surface is 50.5".
3 and 1/4 turns of the driveshaft to turn the wheel.
It is a 10 bolt rear end, I am going to try to identify whether it is a 8.2 or 8.5...

[MGBV8]

It is neither.

It is either a 7.5" or 7.625"  (if '86 or later).

[declan]

$800

[declan]

$500
 I am selling this to help offset the cost of sending a really nice b motor to a shop to be assembled so I can drop that in my car. Someone with a nice v6-or v8 project needs this more than I do.

[declan]

Still available. PM me if you need specific information, such as numbers stamped on the housing or need something measured, calculated...

[declan]

*SOLD*