MGA B Pillar fitting

[Richl705]

Working on placing new B Pillars on my project MGA but when I test fit them the small horizontal arms pointing to the rear of the car do not touch the body.  They are are off the body by about 3/4".  I am certain they should be touching or they will not hold for welding, but it is the same on both sides.  Has anyone else run into this issue?

[Bill Young]

Richard you are corrct, the triangular shaped reinforcements should touch the body. I didn't have to replace the entire B post on my MGA only the lower couple of inches in my case. Here's a couple of photos that might help you see how the B post fitted on my car.

[Richl705]

Great.  Will make that right.  Thanks much.