V8 T5 and clutch disc comments

Started by denvermgb, May 20, 2012, 09:15:09 PM

Previous topic - Next topic

denvermgb

I installed my rebuilt V8 T5 yesterday. A few thoughts....

Quite a difference after running a V6 T5, like a different car! 1st and 2nd gear are very useful, and my highway cruising speed is @2000 RPM's at 60 MPH.

I was surprised to see that the stock clutch disc from a V8 Camaro/Firebird (approx 1985 and up) to be 10" in diameter.  I had an Astro van clutch disc with my V6 T5 and it is 11" in diameter and also has a smaller inside diameter, creating much more "meat" of clutch material.  I met with my SBC guru who does lots of Camaro's, Vette's, S-10's etc.  He said the 10" diameter clutch disc is the correct one.  I should have photographed them side-by-side yesterday, but I really wanted to get that baby together.  

I wish I could be in Palestine but some of us have to work to support the rate of our goverment's spending!

Brad

djw090


denvermgb


pcmenten

I think you might be able to bring both your Astro van clutch plate and your V8 clutch plate to a clutch rebuilder and have them use the V8 hub to make an 11' plate for you. I did something like this at a place in Seattle, on 15th Ave E. if I remember correctly. Next to REI. The guy there suggested it to me. I was dubious but accepted the suggestion and was happy with the results.