Wanted rods for 3.4" stroker kit buick 215

[Wotland]

Hello, I am looking for either 5.7" narrowed chevy rods or modified buick rods to accept for Ford 0.912" wrist pin.

Thank.

[roverman]

Get your Chevy rods yet? Don't recommend the Buick"cast" rods. Anyone with a engine lathe that will, "swing" the chev. rod can carefully narrow them. Use a 6 jaw chuck or an internal expanding mandrel. Watch the "off-set"! I think it's around .030" vs. .070", side/side to get top of rod on-center. D&D ?  Good Luck, roverman.