Print Page - Serpentine belt pulleys

Title: Serpentine belt pulleys
Post by: NixVegaGT on March 26, 2009, 05:12:01 PM

Can I just buy the crank pulley off of a Discovery or something to use a serpentine belt? I found one on ebay for $45. I suppose I could find one for cheaper somewhere.

Title: Re: Serpentine belt pulleys
Post by: NixVegaGT on March 27, 2009, 09:06:47 AM

Here's a pic. The center hole looks all wrong. Like it's too big. Anybody?
2072_1.JPG

Title: Re: Serpentine belt pulleys
Post by: NixVegaGT on March 30, 2009, 09:15:18 AM

I think this is wrong. I found a pic with a ruler along the side of it. It looks just like this one. That means the center hole is 2 3/4" dia. WAY too big. I measured my Buick 300 balancer and it measured 2 1/8". Big difference. Does anybody know any details? Like balancer differences vs. year. It sounds like the 4.2L drive pulley is the best bet.

Title: Re: Serpentine belt pulleys
Post by: BlownMGB-V8 on March 31, 2009, 11:15:37 PM

You might look at the V6 systems.

Jim

Title: Re: Serpentine belt pulleys
Post by: NixVegaGT on April 01, 2009, 07:42:43 PM

Yeah... I like the idea, Jim. I'll see what I can find out.

BritishV8 Forum

General Category => Engine, Transmission, & Rear Axle assy. => Topic started by: NixVegaGT on March 26, 2009, 05:12:01 PM