Hi,
I'm currently trying to integrate my Duraspark ignition wiring into my Advance Auto Wire power block harness. Something more than a few members have done.
My Duraspark is wired using a painless performance kit.
https://painlessperformance.com/wp-content/uploads/2024/02/30812.pdf
Attached is a photo of how I think the setup should be integrated. My goal is to use the AAW wires as much as possible.
Does the attached setup look right?
25_04_18durasparkandAAWinstallation.png
The only issue that I can see is the White wire from the DS module.
It should run to the "I" terminal of the starter solenoid.
Functionally, no problem just a detail.
Cheers Fred