BritishV8 Forum

General Category => Triumph Sports Cars => Topic started by: oldguy on August 31, 2019, 02:23:35 AM

Title: TR6 electric steer - EPS
Post by: oldguy on August 31, 2019, 02:23:35 AM
My version of electric steering. not as polished as some of the others, but very easily accomplished.


TR6EPS1.jpg

TR6EPS2.jpg

TR6EPS3.jpg
Title: Re: tr6 electric steer
Post by: MGBV8 on August 31, 2019, 09:19:06 AM
Probably because they are too large.  There are a number of free online sites to bring them down to a manageable size.  Drop the width to 600 pixels.
Title: Re: tr6 electric steer
Post by: dwtr6v8 on September 01, 2019, 08:10:24 PM
Do post details, I'm still playing with my conversion.
Title: Re: tr6 electric steer
Post by: oldguy on September 09, 2019, 11:16:41 AM
Carl was going to reconfigure the photos so they could be up loaded.
I mounted the the unit in the engine compartment. I used a 1/2 drive universal joint to couple the the unit to the steering column. I shaped the male end of the universal to fit into the column and used the original clamp to secure the joint. I shortened the input shaft of the unit and machined it square to fit into the female end of the universal joint. A standard universal joint connected the output to the intermediate shaft. A couple of angle brackets hold the unit in place.
All in all pretty simple conversion.
Title: Re: TR6 electric steer - EPS
Post by: MGBV8 on September 11, 2019, 10:05:33 AM
First post now has pics.
Title: Re: TR6 electric steer - EPS
Post by: oldguy on September 11, 2019, 10:32:41 AM
thanks Carl
Title: Re: TR6 electric steer - EPS
Post by: dwtr6v8 on September 11, 2019, 07:24:38 PM
Ken mounted his in the engine bay as well.

I would need to relocate my battery to the trunk.

I may explore this option.

Thanks for the pics!
Title: Re: TR6 electric steer - EPS
Post by: hoyt on December 10, 2019, 02:57:11 PM
What car is the steering unit sourced from?
Title: Re: TR6 electric steer - EPS
Post by: oldguy on December 12, 2019, 06:05:11 PM
the power unit is from a Saturn Vue, it is also used in some gm vehicles.
there are several companies that sell the control unit so that an ecu isn't needed
a pot is incorporated to control the amount of assist
it's worked out pretty well, I would like more centering of the wheel, but that was an issue without the power assist.
I plan on adding more castor for better feed back
Title: Re: TR6 electric steer - EPS
Post by: BlownMGB-V8 on December 17, 2019, 10:58:39 AM
I've found that in limp mode the EPS units tend to give about 50% assist which is just about right. They do have a short delay while they are looking for an outside computer so initialization takes up to as much as 3 seconds in some cases. But no real need for any external controls.

Jim