BritishV8 Forum

General Category => Bodywork, Paint, Interior, Trim, & Wiring => Topic started by: cincitr4a on November 30, 2008, 09:10:24 PM

Title: Butt Hammer Welding
Post by: cincitr4a on November 30, 2008, 09:10:24 PM
Hello All,
I was just looking at the Randy Schultz TR3 website and he mentioned a metal welding technique called butt hammer welding using oxyacetylene gas welding vs. MIG or TIG welding. I can't find anything more on the web about this. Does anybody know how to contact Randy or some other source of knowledge on this?
Thanks
Title: Re: Butt Hammer Welding
Post by: rficalora on December 01, 2008, 05:49:48 PM
Check out this article from Rod & Custom...

http://www.rodandcustommagazine.com/techarticles/hammer_welding_overview/index.html

Essentially, it's just butt welding & working the seam with a hammer/dolly as you go to keep the metal from getting out of shape.  the oxy weld is a lot softer than a MIG weld so it's easier to do it that way... but you can use a MIG & achieve the same functional result.  No matter what you weld with you need to go very slowly & ensure you're not getting warping...