Print Page - buick crankshaft

Title: buick crankshaft
Post by: drzee on November 02, 2008, 08:02:01 PM

i am looking for a buick 300 cu in crankshaft for an allluminum block rover motor. I think it is somewhere in the 1964 era. I need one that is not cracked (obviously) and has not had the poop machined out of the journals .... Anyones help would be greatly appreciated

Title: Re: buick crankshaft
Post by: drzee on November 16, 2008, 11:11:30 PM

can you send me a picture and sizes of the rod and main bearings??

Title: Re: buick crankshaft
Post by: harv8 on November 17, 2008, 11:13:43 PM

Hi Bill,

I have a Buick 300 crank and the pistons to go with it. I can post a pic for you.

FYI - I also have a complete stroker kit for the Rover engine that comprises of the Buick crank, Ford pistons, Rover rods, and Buick heads.

Cheers,
Martyn

Title: Re: buick crankshaft
Post by: harv8 on November 17, 2008, 11:51:45 PM

Here's a pic. I can send journal sizes as well but I will have to measure them if you're interested. I need a day or two though.

Cheers.
Buick300crank532.jpg

BritishV8 Forum

General Category => Classified Ads: Swap Parts Here! => Topic started by: drzee on November 02, 2008, 08:02:01 PM