BritishV8 Forum

General Category => MG Sports Cars => Topic started by: hirot on November 20, 2012, 03:03:56 PM

Title: Thin water pumps
Post by: hirot on November 20, 2012, 03:03:56 PM
I have a 3.9 V8 I have put into my MGB GT and was trying to fit a puller fan rather than use the two pusher fans. However, the standard P6 water pump has a long nose, which is not used and stops about 40mm from the radiator.

Has anyone used  a QCP2059 or Buick pump or cut off the front of the P6 pump. I have a standard SD1 timing cover and have the usual GWP310 pump, which wasn't cheap so I am loath to just grind the front off and then try and thread it and then align the pulley.

I have read a thread where a pump was cut down but can't remember which timing cover was used.

An alternative is to tilt the radiator forward about 3/4" which appears to give me space....but how far does the engine move under braking and acceleration  ?                  

Any help will be greatly received.

Regards Ian
Title: Re: Thin water pumps
Post by: mstemp on November 20, 2012, 03:39:33 PM
Ian,

I think you can use a Buick 300 WP. Over here they are about $50 brand new. May take some fiddeling to line up with the SD1 balancer though. There was a recent post on this at:

http://www.mgexperience.net/phorum/read.php?40,2212024
Title: Re: Thin water pumps
Post by: Moderator on November 21, 2012, 05:54:54 PM
Does this old article help?
http://www.britishv8.org/Articles/Shortie-Water-Pump.htm
Title: Re: Thin water pumps
Post by: mgbazza on November 25, 2012, 10:08:49 PM
PB250195.JPG
PB250196.JPG

  This is a water pump from a P6 Rover. The end was chopped off & the flange ,was drilled & tapped 10/32. The pulley was then screwed onto the flange.I left the spigot in situ as a guide for drilling.
Title: Re: Thin water pumps
Post by: BlownMGB-V8 on November 26, 2012, 08:22:36 AM
The Buick 300 pump comes in two versions, aluminum and cast iron body. Other than that I think they are the same.

Jim