Here's an update on my new car.
Should be test driving in 2 weeks!!!
Cheers,
Martyn
ExhaustInstalled25small.jpg
Looks great Martyn.I like the stance, just down in front a bit. Hope you can bring it to Omaha next June.
Classic!
Very nice, Martyn. I too like the stance. Along with the colour, it makes the car look a bit agressive from this viewpoint. I credit you with helping me make the final decision to start with a conversion. It started with me poking around in and under your car in your garage one wet and cold day in Waterloo what seems like many years ago.
What Martyn neglected to mention is that he's joined the SBF crowd.
Great stance Martyn; beautiful car, I'm seriously considering painting my GT black, you can't beat that classy look. Please do a "How-It-Was-Done." While I was going through radiation treatments I aquired about everything I need to finish mine except a new gas tank; starting to run out of storage space. Trying to get to Omaha too.
Paul
QuoteWhat Martyn neglected to mention is that he's joined the SBF crowd.
Nooooooo!! Say it ain't so Martyn!
You acquire a TVR, then you want yank out the perfectly fine 350 Chevy engine, then you go and stick a F... motor in a perfectly fine MGB/GT. What is in the Canadian water?!! ;)
I think the stance is perfect, as well. It just has too much ground clearance, for me. :) :)
Martyn, Car looks great! Did you use the narrow Toyota 4X4 caliper with the stock rotor or the wider one with vented rotor? Proportional valve for rear disc?
Here's the link to the project. Most of your questions will be answered here.
Thanks so much........I need all the encouragement I can get to see this thing through to the end.
I have studied so many of your great cars to help me put this one together. Thanks everyone!!!
http://forum.britishv8.org/read.php?13,6428
Awesome, Martyn!
Almost done.....just in time for Winter.
That's a lot of work there Martyn - well done!
Beautiful job Martyn.
Martyn, I applaud your efforts! Well done my friend!
I have not paid as much attention as I should have to how the crossmember strengthening has been accomplished since I had no intention of doing that (TR6). Now, I find that it may be necessary, and wonder: did you add additional structural cross pieces to the hollow section of the crossmember, or something else?
Thanks,
Dennis
BEAUTIFUL ! Look fwd to seeing in Omaha
Very nice Martyn. The black looks awesome!
You have a PM from me, Martyn.
Wow , what a job !! and you can still get a month of driving in before winter!
Dave
Looks good!
Jim
Martyn!
SWEET!
But that's not black-- it's a very dark GREEN, yes? Brooklands of some sort?
Can't wait to see it Cruising in person... :-)
max
It is black........just black......it's all black, outside and in.
Test drive has been delayed due to leaking rad and brakes that just won't bleed.
I was doing great bleeding them until I ran the reservoir dry......now I'm thinking I have an air pocket in the master cylinder.
I can't get any fluid out of the rear bleed screws and the rear brakes won't work. My rad had some leaking issues where I had welded the brackets to hold the AC condenser. Hope to test drive next week end.
ExhaustInstalled15small.jpg
Looks great, Martyn!
Rear brakes are overrated. ;)
My bad :-) Thought I saw a reflection of green in some of the paint shots... :p Looks fantastic!
RE: brakes. If you have some kind of Pressure Differential in the system, still, it may have just slid this to the other side (blocking off the rears). Open up the fronts again and do a few pumps there and then go back to the rears and see if that changes anything.
$.02
M