BritishV8 Forum

General Category => Bodywork, Paint, Interior, Trim, & Wiring => Topic started by: roverman on May 16, 2012, 06:31:07 PM

Title: TR7-8 windshield trim, buy windshield ?
Post by: roverman on May 16, 2012, 06:31:07 PM
Where to buy? Lot's of "scalpers" ! Special tool to remove ? Suggestions ? Thanks, roverman.
Title: Re: TR7-8 windshield trim
Post by: tr8todd on May 16, 2012, 10:45:56 PM
Pry out slowly starting in the bottom corners.  Don't use the glass as a leverage point, or it will crack.  Use a a thin slice of wood under the prying tool against the metal windshield frame and try to slide your finger tips under the side against the glass as it lifts.  Even if your careful, the windshield may still break or the two layers of windshield may delaminate at the top corners.  All depends on the adhesive used.  Original windshields had a wire buried in the sealant that supposedly could be hooked up electrically and the resistance in the wires would heat the sealant making it easier to remove.  Never seen it work in real life.
Title: Re: TR7-8 windshield trim
Post by: Moderator on May 16, 2012, 11:54:41 PM
QuoteNever seen it work in real life.

But what a nifty idea.
Title: Re: TR7-8 windshield trim
Post by: roverman on May 17, 2012, 11:32:36 AM
Glass is already cracked. Likely not original glass,(race car/body in white). Just trying not to ruin trim or clips. Thanks, roverman.
Title: Re: TR7-8 windshield trim
Post by: tr8todd on May 17, 2012, 05:04:21 PM
If you ruin them give me a shout.  I have a pile of at least a dozen or so sets.  It's that bugger little filler strip at the top that always seems to go missing.
Title: Re: TR7-8 windshield trim
Post by: roverman on May 17, 2012, 06:35:33 PM
How about pushing sideways that "stradle clip", center/top of trim ? I'm still having trouble getting wiper nuts off.Cheers, roverman.
Title: Re: TR7-8 windshield trim
Post by: tr8todd on May 18, 2012, 09:07:37 AM
If it's there.  Most times it's gone on parts cars.
Title: Re: TR7-8 windshield trim, succes at last !
Post by: roverman on June 06, 2012, 02:39:13 PM
Had I only known the trim is set with RTV silicon ! I was expecting clips/ old school ? Once one end started to give, WD-40 type lube really helped losen the stainless. Used a winshield adhesive cutting tool,(worth weight in gold), to extract the glass. Now, where do I buy a polycarbonate windshield ?  Onward, roverman.