Text only | Text with Images

BritishV8 Forum

General Category => Classified Ads: Swap Parts Here! => Topic started by: pgfkr on January 21, 2012, 11:20:53 AM

Title: Wanted buick/rover 215 to MGB transmission adapter plate
Post by: pgfkr on January 21, 2012, 11:20:53 AM
looking for the transmission adapter plate that allows MGB transmission / bellhousing to mount to buick/rover v8.
I think there are some guys on the board that have one installed.
If anyone has one lying around I could purchase or could email me a dimensioned drawing I would be etternaly grateful.
Cheers
John.
Title: Re: Wanted buick/rover 215 to MGB transmission adapter plate
Post by: WedgeWorks1 on January 21, 2012, 07:40:45 PM
Last I heard and this was YEARS ago to put a MGB tranny on a rover you have to remove/cut off some parts of the rover block where the starter is......It is a ton of work and when your done you have outside of using the engine on a MGB tranny a useless engine for any other transmission.
Title: Re: Wanted buick/rover 215 to MGB transmission adapter plate
Post by: pgfkr on January 22, 2012, 12:14:53 PM
Yes, I am aware of this  :-)
Title: Re: Wanted buick/rover 215 to MGB transmission adapter plate
Post by: psmg on February 03, 2012, 06:11:05 PM
John,
  I have the complete setup. Adapter plate, proper flywheel, pressure plate, newly rebuilt MGC clutch disk, slave cylinder and starter. Let me know if you're interested.

Paul
Title: Re: Wanted buick/rover 215 to MGB transmission adapter plate
Post by: rfsmith48 on February 07, 2012, 02:01:23 PM
There is a guy in Denver/Aurora CO that had one of these setups. You  might try Denver Craigslist or the TR8 forums.

Rog
303 494 0140
Text only | Text with Images