I want to go to a 4 or 5 lug, preferrably a 5 lug, replacement for the knock off spindles....
any suggestions where to look?
thnx
Machine the splined portion off. Drill hub to 5X4.75 lug pattern. Or if the bolt pattern bolting the wire wheel hubs is that already use a 1" spacer like picture below. S-10 rear has same pattern. Rear on 83-92 S-10 2WD is only 54" wide. Might not even have to be narrowed.
5135-5450V-2.jpg
where do i get a spacer like this?
Here's another approach: http://modifiedhealeys.org/Technical/Wire-2-SolidWheelAdapters/Wire-2-SolidWheelAdapters.htm
thanks for the heads up, i found the spacers at multiple locations, i just need to take some measurements on the car. then i can put it together. fo rthe meantime i'll use the wire wheels i have. they're just a lil rusty and too expensive to replace (for right now anyway). i'm planning to put some mustang svt wheels on it.... or something similar.