BritishV8 Forum

General Category => Classified Ads: Swap Parts Here! => Topic started by: Bugeyev8 on June 05, 2011, 11:34:10 AM

Title: Megasquirt 2 Version 3 Standalone EFI System
Post by: Bugeyev8 on June 05, 2011, 11:34:10 AM
I have a Megasquirt 2 version 3.57 I am not going to use, It was purchased assembled from DIY auto tune about 2 years ago and run in a Bugeye with a Toyota engine for about 300 miles, it runs fine, we just went a different route

Its set up for the ford EDIS ignition and the 4 cylinder system is included, It has the Jim Stim Simulator and power supply, serial cable, and the 12 inch harness, I also have an Innovate LC1 wide band O2 sensor with gauge also included , most sensors are also included as well as wiring lengths for each, will try to include the Tuner Studio licencse if I can..so you can use the best tuning software availible

asking 450$ for the set up

just the MS2 and the O2 were over 600$

510-706-0169
Title: Re: Megasquirt 2 Version 3 Standalone EFI System
Post by: Jerminator96 on June 06, 2011, 12:14:50 PM
Take it from a guy who just bought all of this stuff new, that is a killer deal.  I wish I had seen this a month ago.
Title: Re: Megasquirt 2 Version 3 Standalone EFI System
Post by: Bugeyev8 on June 06, 2011, 04:42:19 PM
Thanks !! Its priced fair and I am glad someone sees that...needs a new home soon !!
Title: Re: Megasquirt 2 Version 3 Standalone EFI System
Post by: Bugeyev8 on June 07, 2011, 11:17:34 PM
SOLD ON EBAY