BritishV8 Forum

General Category => MG Sports Cars => Topic started by: barrysmgb on December 25, 2010, 07:37:37 PM

Title: fabricating rear trans mount t5
Post by: barrysmgb on December 25, 2010, 07:37:37 PM
302/t5  tranny mount want to bolt in best to drill thru frame into interior with gr 8 bolts or angle bracket and bolt hort thru frame rail parallel to floor saw one bolt vert in pics here but could not see if they went thru floor thanks barry
Title: Re: fabricating rear trans mount t5
Post by: rficalora on December 26, 2010, 04:26:47 PM
best to make the tranny mount use the existing holes/captive nuts in the frame rails.
Title: Re: fabricating rear trans mount t5
Post by: mgbreis on December 28, 2010, 08:05:27 PM
No need to reinvent the wheel, the stock crossmember works fine. I cut out the center section of the mount with a cut off wheel and welded in a 3/8" plate that bolts to the transmission. I snapped a couple pics to give you the idea (hard to take pics of something 6" off the ground. Ignore the bolts, they're too long and just temporary. Or maybe permanent the way my project has ground to a halt. I should mention that my mount incorporates a urethane mount for a fox body mustang.

(http://i29.photobucket.com/albums/c298/mgbreis/IMG_0107.jpg)
(http://i29.photobucket.com/albums/c298/mgbreis/IMG_0106.jpg)
Title: Re: fabricating rear trans mount t5
Post by: ex-tyke on December 28, 2010, 08:48:10 PM
Ryan's approach pretty well mirrors mine. There's a set of 3 tapped holes in each chassis member - depending on your fore/aft engine location, you may have to use the rear 2 and add another couple of matching holes to the crossmember.
Title: Re: fabricating rear trans mount t5
Post by: pspeaks on December 28, 2010, 11:15:50 PM
Barry, I've attached a picture of my trans mount.  Your looking at the bottom of it but I think you can get the idea.  By all means use the existing holes and nut plates.
MG0025.JPG