fiberglass body

[HughH]

I have a 1958 to 60 LaDarwi Quest QT kit car body that is vintage race period legal.  It is designed for a 94" wheel-base chassis (MG T series or MGA)  I sort of planned on using it on my TD V8 chassis (project)    <BUT> 'might' entertain  trade or sell offers. It is very rare and to my knowlege is the only surviving QT.  

[mgv8news]

If you decide to sell it, what kind of money would you be looking for? Have any idea what windshield fits?

[MGBV8]

Hi Kurt!

Hmmm, I was guessing 56-62 Corvette windshield, maybe?

[Phillip G]

Gentlemen,

The LaDarwi Quest vintage project could be a blast.  Wish I had seen it last Summer.

I began an SCCA GT2 RV8 project last Summer and am now in need of front-end fiberglass - fenders, hood and  grill/spoiler fiberglass parts.  The GT2 RV8 must weigh under 2,080 lb, complete (less driver) and needs fiberglass.

The project is almost complete and we hope to race at Heartland Park (Topeka) late in 2008.

Anybody have info on RV8 fiberglass body parts for SCCA racing ?

Phillip Leonard

=====

Moderator's note: I just deleted Phillip's e-mail address from this post. If you need to get in touch with him, please use the message board's "private message" system.

[HughH]

Hello - hope this sends just found it.   This body is designed to use a Vauxhall Victor windshield from the 1959 to 1962 era.  I'd like to get $2500 for it.  Many who build LaDawris into vintage racers will cut the current windshield off   thanks  Hugh

[hughv]

This body has been sold. I have a 1952 TD frame which is solid rust free with  MGB front disc brakes and Austin Healey 3000 shocks that are a direct bolt on. It has no rear end or springs. Located in North Western Montana
 Its a good start for a vintage racer or MG V8 project.